Fusion Filaments Promo Codes & Coupons November 2026 — Up to 20% Off

On Fusion Filaments Thangs Appearance, you can find the spool that can be refilled, Resin in Matte, Temp for ABS1. 5 Extrusion, Flow Rate: 245 c at 65 mm/s 30-65 mm/s Bed Temperature. 90 to 100 degrees Celsius with PEI or Ultem, or glass coated with glue or hairspray) Diameter. How to mount Fusion Filaments1. 75mm refill coil, Print the refill spool above. Cut open the vacuum-sealed bag in which the filament was packaged and remove the paper discs that covered the coil's top and bottom. Slide the coil onto the 3D printed spool without removing the cardboard core. Leave the four paper straps in place. The refill spool's snap-together mechanism is extremely robust, so it will take some force to snap the two sides together. Cut the paper straps; some paper will remain inside the spool core, which is fine. The filament is now ready to use.